Displayed Messages - DeLonghi ETAM29.620.SB Instructions For Use Manual

Bean to cup espresso and cappuccino machine
Table of Contents

Advertisement

DISPLAYED MESSAGES

DISPLAYED MESSAGES
FILL TANK
EMPTY GROUNDS CONTAINER The grounds container (A15) is full.
GROUND TOO FINE ADJUST
MILL
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
ADD PRE-GROUND COFFEE
DESCALE
REDUCE COFFEE AMOUNT
FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
POSSIBLE CAUSE
Insufficient water in the tank (A20).
The grinding is too fine and the coffee is delive-
red too slowly or not at all.
If the water softener filter is present, an air
bubble may have been released inside the cir-
cuit, obstructing delivery.
been replaced (A15).
With the "pre-ground coffee" function selected,
pre-ground coffee has not been poured into the
funnel (A4).
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The infuser has not been replaced after clea-
ning (A19).
SOLUTION
Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place.
Empty the grounds container and drip tray,
clean and replace. Important: when removing
the drip tray, the grounds container MUST be
emptied, even if it contains few grounds. If this
is not done, when you make the next coffees,
the grounds container may fill up more than
expected and clog the machine.
Repeat coffee delivery and turn the grinding
adjustment dial (fig. 11) one click clockwise to-
wards "7" while the coffee mill is in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see the section:
"Adjusting the coffee mill on page 13). If the
problem persists, make sure the water tank is
fully inserted.
Deliver a little water until the flow becomes
regular.
Remove the drip tray and insert the grounds
container.
Place pre-ground coffee in the funnel or dese-
lect the "pre-ground" function (fig. 16).
The descaling procedure described in the section
"Descaling" needs to be performed as soon as
possible (page 16).
Select a milder taste by pressing the
(fig. 8) or reduce the quantity of pre-ground
coffee.
Fill the beans container (fig. 12).
Empty the funnel with the help of a brush as
described in the section "Cleaning the pre-
ground coffee funnel" (page 16).
Insert the infuser as described in the para-
graph "Cleaning the infuser" (page 16).
20
icon

Advertisement

Table of Contents
loading

This manual is also suitable for:

Etam29.62 series

Table of Contents