Descaling; Install Filter; Replacing The Filter (If Installed); Adjust Time - DeLonghi ETAM29.620.SB Instructions For Use Manual

Bean to cup espresso and cappuccino machine
Table of Contents

Advertisement

If the appliance is not used for more than 3-4 days, we
strongly recommend, when switching on the appliance,
performing 2/3 rinses before using it.

Descaling

For instructions on descaling, see page 16.

Install filter

For Instruction for use on how to install the filter, see the section
"Water softener filter" (page 18).

Replacing the filter (if installed)

For Instruction for use on how to replace the filter, see the sec-
tion "Replacing the filter" (page 19).

Adjust time

To adjust the time on the display, proceed as follows:
1. Press the
icon (B2) to enter the menu;
2. Press
or
displayed;
3. Press the OK icon (fig. 4). The hours flash on the display;
4. Press
or
5. Press the OK icon to confirm. The minutes flash;
6. Press
or
7. Press the OK icon to confirm.
This sets the time. Press the

Auto-start

You can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coffee immediately.
Please note!
To enable this function, the time must already be set correctly.
To enable auto-start, proceed as follows:
1. Press the
icon (B2) to enter the menu;
2. Press
or
3. Press the OK icon (fig. 4). "Enable?" is displayed;
4. Press the OK icon to confirm;
5. Press
or
6. Press the OK icon to confirm;
7. Press
or
8. Press the OK icon to confirm;
9. Press the
icon to exit the menu.
Once the time has been confirmed, activation of auto-start is
indicated by the
symbol displayed alongside the time.
(fig. 7) until "Adjust time" is
to change the hour;
to change the minutes;
icon to exit the menu.
(fig. 7) until "Auto-start" is displayed;
to choose the hour;
to change the minutes;
To disable the function:
1. Select auto-start from the menu;
2. Press the OK icon. "Disable?" is displayed;
3. Press the OK icon to confirm.
The
symbol is no longer displayed.

Auto-off (standby)

Auto-off can be set so that the appliance goes off after 15 or 30
minutes, or 1, 2 or 3 hours.
To programme Auto-off, proceed as follows:
1. Press the
icon (B2) to enter the menu;
2. Press
or
3. Press the OK icon (fig. 4);
4. Press
or
(15 or 30 minutes, or 1, 2 or 3 hours) is displayed;
5. Press the OK icon to confirm;
6. Press the
icon to exit the menu.
Auto-off is programmed.

Energy saving

Use this function to enable or disable energy saving. When en-
abled, the function reduces energy consumption in compliance
with European regulations.
To disable (or enable) energy saving, proceed as follows:
1. Press the
icon (B2) to enter the menu;
2. Press
or
displayed;
3. Press the OK icon (fig. 4). "Disable?" is displayed (or "Ena-
ble?" if the function has been disabled);
4. Press the OK icon to disable (or enable) energy saving
mode;
5. Press the
icon to exit the menu.
When the function is active, if the machine is not used for some
time, "Energy saving" is displayed.
Please note!
When in energy saving mode, a few seconds may elapse
before the first coffee is delivered as the appliance must
heat up again.
To prepare any drink, press any icon to exit energy saving,
then press the icon corresponding to the drink you want to
make.

Setting the temperature

To modify the temperature of the water used to make the coffee,
proceed as follows:
1. Press the
icon (B2) to enter the menu;
2. Press
or
displayed;
11
(fig. 7) until "Auto-off" is displayed;
until the required operating time
(fig. 7) until "Energy saving" is
(fig. 7) until "Set temperature" is

Advertisement

Table of Contents
loading

This manual is also suitable for:

Etam29.62 series

Table of Contents