Table of Contents
Advertisement
Available languages
Available languages
Adjust the fence to be as close to the blade as practical to
provide maximum work piece support, without interfering
with the up and down movement of the arm.
Tighten the high sliding fence clamp (20) to secure the
fence in place.
Warning! The guide groove can become clogged with saw-
dust. Use a stick or low pressure air to clear the guide groove.
Bevel cut
Make sure that the high sliding fence is adjusted to the
correct orientation before adjusting the bevel angle.
Note: The saw is fi tted with a special 33.9° bevel pin (23) for
special crown moulding.
Loosen the bevel lock handle (30) (fi g. F) and move the
cutting head to the required angle. Tighten the bevel lock
handle (30).
Operate the on/off switch, then press the release lever
(36) when the saw reaches full speed, push the main
operating handle (2) down slowly, cutting through the
workpiece.
When the saw reaches full speed, push the main operat-
ing handle (2) down slowly, cutting through the leading
edge of the workpiece.
Slowly move the main operating handle (2) toward the
fence to complete the cut.
Release the on/off switch (3) and allow the blade to stop
before allowing the cutting head to rise.
Make sure that the arm is securely locked when bevelling.
Compound cut
Make sure that the high sliding fence is adjusted to the
correct orientation before adjusting the bevel angle to
make a compound cut.
A compound cut is a combination of mitre cut and bevel cut.
Switch the laser on/off switch (1) to on.
Refer to the above procedures to perform this cut.
When the saw reaches full speed, push the main operat-
ing handle (2) down slowly, cutting through the leading
edge of the workpiece.
Slowly move the main operating handle (2) toward the
fence to complete the cut.
Release the on/off switch (3) and allow the blade to stop
before allowing the cutting head to rise.
(Original instructions)
Base moulding cut
Base moulding can be cut vertical against the fence or fl at on
the table.
Refer to the following table:
Vertical position
Settings
(back of moulding is
against the fence)
Bevel angle
0 º
Moulding position
Left side
Inside
corner
Left at
Mitre angle
45 º
Bottom
Moulding
against
position
table
Keep left
Finished
side of
side
cut
Vertical position
Settings
(back of moulding is
against the fence)
Bevel angle
0 º
Outside
Left at
Mitre angle
corner
45 º
Bottom
Moulding
against
position
table
Keep left
Finished
side of
side
cut
ENGLISH
Horizontal position
(back of moulding is
fl at on the table)
45 º
Right
Right
Left side
side
side
Right at
0 º
0 º
45 º
Bottom
Top
Bottom
against
against
against
table
fi nce
fence
Keep
Keep left
Keep left
right side
side of
side of
of cut
cut
cut
Horizontal position
(back of moulding is
fl at on the table)
45 º
Right at
0 º
0 º
45 º
Bottom
Top
Bottom
against
against
against
table
fi nce
fence
Keep
Keep
Keep
right side
right side
right side
of cut
of cut
of cut
13
Advertisement
Table of Contents
