Table of Contents
Advertisement
1. OPERATIONAL OVERVIEW
1.8
How to Use the Menu
Most operations are carried out from the menu. This section provides basic menu op-
erating information.
1. Press the MENU/ESC key to open the main menu.
Select "Shortcut Menu"
to show the menu title
you programmed.
(See section 6.1.)
Note: You can also show the main menu by pushing the right-click button to show
the pop-up menu. See "Pop-up menu operation" on page 18.
2. Operate the trackball to place the arrow cursor on the item you want to select. The
yellow cursor marks the current selection. You can also use the scrollwheel to se-
lect a menu item.
3. Left-click or press the scrollwheel button when selected with the scrollwheel. If you
selected [TX/RX Setting] at step 2 for example, the following menu appears.
Scanning mode tab
4. Press the H/S/V key to select the display mode.
• H1, H2 tab: Items for horizontal display setting
• S tab: Items for the slant display setting
• V tab: Items for the vertical display setting
Items which you cannot set are shown in gray.
5. Select the item then push the left-click button.
1-16
Menu title
The descriptions for the selected item appears in this field.
This icon means
that this item is
assigned to a
function key.
(Numeric window) (Item window)
Select QUIT with
trackball and then left
click to close the menu.
"..." means that this
item has sub menus.
Advertisement
Table of Contents
