Cursor Position Reference Mark; Auto Train - Furuno FSV-85 MARK-2 Operator's Manual

3.3.3

Cursor position reference mark

The cursor position reference mark, a solid circle, is inscribed on the vertical bearing
mark when the cursor is placed in the vertical display. Its purpose is to show the cor-
responding cursor position on the horizontal display. It changes position with cursor
position, tilt and range, and disappears when its position is no longer within the range
of the horizontal display.
Cursor
position
reference
mark
3.4

Auto Train

You may scan the vertical bearing mark in the sector of ±12°, ±24° and ±36°. Press
and hold down the AUTO TRAIN key, then press the V1/S or V2 key to select the auto
train sector desired. Selected sector appears in large characters for five seconds for
your confirmation. To cancel auto train, repeat the above procedure to select [OFF].
Note: When the target lock function is active in vertical mode, the following limitations
apply to the auto train function:
• V1/S mode: Auto train is unavailable.
• V2 mode: Auto train is unavailable for vertical bearing mark 1.
Turn the target lock function off to re-enable the auto train function in these cases.
V
Vertical
bearing
mark
Cursor
Auto train mark
Auto train
1
sector
Vertical
bearing
mark
3. VERTICAL MODE
VERTICAL
DISPLAY
Tilt mark
3-5