Media Specifications; Media - Toshiba BV420D Owner's Manual

14. Media Specifications

This chapter describes the media specifications.
 Media
Make sure that the media to be used is approved by Toshiba Tec Corporation. The warranties do not apply to
problems caused by using media that is not approved by Toshiba Tec Corporation.
For information regarding Toshiba Tec Corporation-approved media, contact your Toshiba Tec authorized
representative.
 Media type
The table below shows the size and shape of the media that can be used on this printer.
Label without black mark
[ A ]
[A]: Cut position
[B]: Feed direction
[C]: Black mark (on the back side)
Issue mode
Item
[1] Label width
[2] Cut length
[3] Black mark length
[4] Black mark width
Thickness
Max. outer roll diameter
Roll direction
Inner core diameter
1. To ensure print quality and print head life, use only Toshiba Tec Corporation approved media.
2. A label jam is more likely to occur with the approach of label end because labels around the paper core curl
intensely.
[ 2 ]
[ 1 ]
Label with black mark
[ A ]
[ B ]
Cut mode
32.0 to 102.0 (1.26 to 4.0)
25.4 to 152.4 (1.0 to 6.0)
6.0 to 10.0 (0.24 to 0.39)
Min. 8.0 (0.32)
0.06 to 0.19 (0.0024 to 0.0074)
Ø107 (4.2)
Outside wound
38.1 (1.5)
[ C ]
[ 3 ]
[ 4 ]
[ 2 ]
[ 1 ]
Unit: mm (inch)
14. Media Specifications 31