Sanyo MAR-B1021 Operating Instructions Manual page 5

Auto Memory Store Function
This function automatically locates and stores up to six stations, starting from the current
point on the selected band. Press and hold the ATP button for more than 2 seconds to
begin the ATP operation. After automatically storing the station, preset scan will begin,
starting with preset number 1. Preset scanning will continue until it is canceled.
• If ATP is started in the DISTANT mode, the selected band will be scanned once.
• If ATP is started in the LOCAL mode, the selected band will be scanned up to three times
- twice in the local mode, then once in the DISTANT mode.
• If ATP is started while a preset station is selected, the current preset station will be
replaced by the next available station on the selected band. (Some other preset stations
may also be replaced, depending on signal strength.)
7. EJECT ( )
Push this button to eject the cassette.
8. FAST FORWARD/REWIND/DIRECTION BUTTONS
Forward Play Mode
Fast Forward: Press
Rewind:
Reverse play Mode
Fast Forward: Press
Rewind:
Direction:
9. PRESET MEMORY BUTTONS (1, 2, 3, 4, 5, 6)
These buttons are used to select and store stations in the preset memory. A total of 30
stations can be stored (18 FM and 12 AM). To memorize and recall preset stations, follow
the steps below.
- Store stations in memory
Select a band (FM1, FM2, FM3, AM1, AM2), then tune in the station you wish to store.
Press and hold one of the preset buttons (1-6) for more than 1 second to store the station.
A 'beep' will sound when the station has been stored in memory.
- Recall a preset station
Select a band (FM1, FM2, FM3, AM1, AM2), then press one of the preset buttons (1-6)
to select a preset staion. The selected preset number will appear on the display.
10. TIME FREQUENCY SELECTOR (CLK)
During radio operation, press this button to recall the time display. Press the button again
or activate any tuning function to restore the frequency display. (The frequency display will
return after 5 seconds if no other button is pressed.)
SETTING THE CLOCK
1. Rotate the volume control to turn the power ON.
2. Press the CLK button (10) to select the time display.
3. Press and hold the CLK button (10). While holding the CLK button, rotate the tuning
control (6) counterclockwise to set the hour or clockwise to set the minutes.
11. BAND SELECTOR (BND)
Press this button to change the selected band in the following order:
12. MONO/STEREO SELECTOR (M/S)
Press this button to switch the radio between stereo mode and mono mode. When the
stereo setting is selected, the ST indicator will appear on the display when an FM stereo
broadcast is received.
13. LOCAL/DISTANT SELECTOR (L/D)
Press this button to select local or distant mode. Select the local mode to receive only the
strongest stations. Use the distant mode to receive all stations, including ones with weak
signals. The system is set initially to the distant mode.
(This function only operates in the FM mode.)
Press
Press
Press both buttons simultaneously to change the direction of tape travel.
FM1 FM2 FM3 AM1
3
AM2