Lenovo 7D2C User Manual page 42

A A b b o o u u t t t t h h i i s s t t a a s s k k
• The kit should be installed by a qualified professional specified by Lenovo service.
• The product should be installed where its weight can be fully supported. If the product is installed on a
weak surface, the product may fall, causing damage t to components.
• When moving or replacing the cabinet after installation, contact a qualified installer specified by Lenovo
service. Installation or movement of the product must be carried out by a skilled professional. If an
unqualified person moves and installs the product, it may cause safety risks.
CAUTION:
The weight of this part or unit is more than 55 kg (121.2 lb). It takes specially trained persons, a lifting
device, or both to safely lift this part or unit.
See the following table to identify the components that come with the rail kit.
1 One upper wall mounting bracket
2 One lower wall mounting bracket
3 Four mounting bolts
The following tools are required for this procedure:
• One tool with plastic blade/scissors
• One combination wrench
• One hammer drills with Dia. Ø14 bits
P P r r o o c c e e d d u u r r e e
Step 1. Measure the wall and drill the four mounting bolts based on the following requirements:
32
ThinkSystem Micro DataCenter 6U 800mm Deep Rack Cabinet User Guide
4 Four hex nuts
5 Four washers
6 Four washers