WAGNER 2361555 Manual page 51

W 950 Flexio W 950 Flexio
Problem Cause
•
Spray jet is
uneven/ not
•
constant
•
•
•
Coating
material causes
"paint tears"
•
•
Too much fog of
•
coating material
(Overspray)
•
•
Width of paint
spray cannot be
•
adjusted
•
Poor covering
capacity on the
wall
•
•
•
•
Coating
material cannot
•
be atomised
Coating material in container
running out
Nozzle seal worn
Air filter heavily soiled
Filter clogged at suction hose
Too much coating material
applied
Viscosity of coating material too
low
Distance to the object too large
Too much material quantity
At a low quantity of material, wide
spray jet selected (black)
Adjustment ring is not connected
to the peg on the air cap
Air screen is clogged up
Spray material is too cold
Highly absorbent surface
or paint with poor covering
capacity
Distance too large
The material quantity and spray
jet do not correspond with each
other
Multifunction switch is set to
"Clean"
Turbine is defect
Remedy
➞ Refill
➞ Replace
➞ Change
➞ Clean filter
➞ Turn the material volume
setting to the left
Spray excess material on the
wall using the inking roller
➞ Reduce the quantity of
material and apply in several
layers
➞ Reduce distance
➞ Turn the material volume
setting to the left
➞ Switch to narrow jet spray
(white)
➞ Connect adjustment ring
and peg
➞ Disassemble and clean the
spray head
➞ The material you are
spraying should be at room
temperature
➞ Cross spray (Fig. 8)
➞ Closer to the object
➞ Optimise the settings
➞ Set the multifunction switch
to "ON"
➞ Please contact Wagner
Service
GB D
49 49