Multifunction Switch Settings (Fig. 4, A); Setting The Flow Rate When Working With The Spray Lance (Fig. 4, B); Setting The Width Of The Spray Jet On The Spray Lance (Fig. 5) - WAGNER WallPerfect Flexio 995 User Manual

GB D
12.
Multifunction switch settings (fig.
FILL/  Settings for cleaning and
CLEAN pre-filling the system
OFF  System is off
ON  Operating setting
When using the spray
i
attachment for varnish paints
and glazes, the FILL/CLEAN
functions may not be used!
13. Setting the flow rate when working with the spray
lance (fig. 4, B)
The material quantity is set depending on the characteristics of the material (viscosity)
and the working speed of the operator.
This setting can be made variably with the material flow limiter:
lower material
higher material
We recommend starting with a low material flow setting and then gradually
i
adjusting this to suit needs. .
14. Setting the width of the spray jet on the spray lance
(Fig. 5)
A = wide spray jet
(green)
B = narrow spray
jet (red)
42 42
turn to the left

turn to the right

 For coating larger surfaces
 Working with a large flow
rate (green area on quantity
scale)
 For coating smaller areas,
corners and edges
 Working with a small flow
rate (red area on quantity
scale)
WallPerfect Flexio 995 WallPerfect Flexio 995
4, A)

OFF
Fill/
CLEAN
A

A
B
B