G60025; Control Knobs; Operating - TREVIDEA G3FERRARI G60025 User Manual

place leave at least half a meter on each side of the unit.
- Do not use the unit near steam or water (sink, shower,
toilet ...). Do not use as a shelf support for objects.
- Do not cover for any reason, subject to overheating.
- Do not use in rooms smaller than 4 square meters.
The product is equipped with an automatic switch-off that
comes into play in case of overheating. If the product fails
during use, check that the ventilation openings are not
blocked, unplug the unit and allow to cool down for 15
minutes before operating.
WARNING: Do not use this heater in small rooms
when they are occupied by persons not capable of
leaving the room on their own, unless constant
supervision is provided.
The appliance must not be placed immediately below a
power outlet.
DESCRIPTION G60025
1 Heating slots
4 Function control knob
7 Fan power-on button

CONTROL KNOBS

Turn the temperature control knob (3) clockwise to increase the temperature to be reached before shutting
down the heater. The function selection control knob (4) has the following modes:
"O" means the unit is off
"2" medium power

OPERATING

Install the appliance as described in the General and Safety Information paragraphs.
Turn the function control knob (4) to the desired position. At first use, the appliance may emit some smoke or
strange smell; this is normal and it finishes after a few minutes of use. Turn the temperature control knob (3)
clockwise until it stops. At this point, the heater turns on.
TEMPERATURE SETTING
Operate the unit by switching the temperature control knob (3) to the highest position until the desired
temperature in the room is reached. Turn the temperature control knob (3) counterclockwise until you turn off
the product, then it will turn on periodically to maintain the temperature.
FAN MODE
To obtain a more efficient heating, the product is equipped with an internal fan (8) that can spread heat in the
room faster. To operate, switch on the fan power button (7).
OVERHEATING PROTECTION DEVICE
If you cover the device or there is a malfunction, the product may overheat. A safety device will shut down
the unit to prevent overheating. Remove anything blocking the ventilation slots and wait for the complete
cooling of the unit, then the appliance works normally.
2 Handle
5 Working light
8 Air outlet grid
"1" low power
"3" high heating power
3 Temperature control knob
6 Feet
9 Main body 10 24 hour timer
12