5 Electrical Installation
The digital outputs are potential free relay outputs. Connect a power supply
unit maximum 250 VAC, or 30 VDC, 5 A.
The digital outputs are configurable to be normally open or normally closed.
Analog output
8. Connect the analog output cables to the analog output terminal.
The analog output is active. The external circuit does not need an external
power source.
Signal
4 mA
20 mA
Power
9. Connect the power cables to the + 24 VDC terminal.
The power supply unit must fulfill isolation class II.
5.2.2 Set the switches
Set the switches.
Switch
NODE ADDRESS, 0–9
MASTER/SLAVE
TERM, ON/OFF
The groove is perpendicular to the arrow in the node address setting. This
image shows node address 1.
18
NO/NC
PSU
COM
-
AO
+
Correct setting
All the node addresses in the system must be unique and not 0.
MASTER
ON
APP 412 Installation, Operation, and Maintenance manual
Description
Minimum level
Maximum level