Siemens SIMATIC RF186C Operating Instructions Manual page 86

Configuring with the WBM
7.3 The menu items of the WBM
Log settings for service
In the "Log settings for service" area, you can define which message types are also entered
in the log.
Table 7- 17
Parameter
Communication channels
CMD_XML
CMD_PLC
CMD_WEB
CM_DEVICE01
CM_DEVICE03
CM_DEVICE03
CM_DEVICE04
Service logbook
The "Service log" area shows all the message types that were selected in the "Log settings
for service" area.
The entries contain the following properties:
Table 7- 18
Property
Date/time
Type
Entry
With the "Update", "Save as" and "Reset" buttons, you can control the entries:
● Update
The log is read in again by the communications module and the list is updated. The
displayed log entries contain 200 KB of data.
● Save as
The log read out by the communications module is saved as a *.csv file.
● Reset
The log is deleted in the communications module.
● Service file
The log read out by the communications module is saved as an *.slf file. The service file
contains additional information relevant to Siemens service personnel.
86
Description of service log parameters
Description
Frames on the XML interface
Internal frames on the PLC interface
Internal frames between Web server and reader
Frames on reader interface 1 (X21)
Frames on reader interface 2 (X22)
Frames on reader interface 3 (X23)
Frames on reader interface 4 (X24)
Displayed properties of the log messages
Description
Time stamp when the entry was made by the communications module.
Note that the time stamp is generated by the device clock (UTC time). This
time is compared with the time zone set on the PC and displayed accordingly.
Type of message
Which message types are signaled depends on the check boxes enabled in
the menu item "Settings - General" in the "Log settings" area.
Text of the message
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 06/2019, C79000-G8976-C512-02