Rfidsettings - Siemens SIMATIC RF186C Operating Instructions Manual

Programming via the OPC UA interface
9.2 OPC UA variables
Description
Possible values
Table 9- 8
Path
Data type
Access
Description
Possible values
9.2.5

RfidSettings

You can make the RFID settings on the communication module using these variables.
Table 9- 9
Path
Data type
Access
Description
Possible values
108
Definition of the data type for the "RWData" diagnostics variable
and the "ScanData" union used for "RWData" in the "RfidLastAc-
cessEvent".
The types "String", "ByteString" and "ScanDataEpc" are support-
ed. The type definition of "CodeTypesRWData" is "MultiStateDis-
creteType". This means that the variable has an "Enum" that
indicates the supported data types as "Property".
•
•
•
DeviceClock
Root/Objects/DeviceSet/Read_point_x/RuntimeParameters/Com
monSettings/DeviceClock
UtcTime
R/W
The internal device clock of the communication module
The communication module loses the time when it is switched
off. The time can be applied after switch-on by this variable via
the application.
Example:
2018-05-29T08:29:15.812Z
MinRssi
Root/Objects/DeviceSet/Read_point_x/RuntimeParameters/RfidS
ettings/Antennaxx/MinRssi
Int32
R/W
Lowest accepted RSSI value of an antenna
Transponders which are detected with a lower RSSI value are
counted as not detected. This is a value without a unit and with-
out direct reference to the power strength.
This variable is only supported by UHF readers.
0 ... 255
0: ByteString
1: String
2: ScanDataEpc
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 06/2019, C79000-G8976-C512-02