Siemens SIMATIC RF186C Operating Instructions Manual page 105

Diagnosis - LastAccess
Client
Command
Identifier
Timestamp
RWData
Antenna
CurrentPowerLevel
PC
Polarization
Strength
Diagnosis - Logbook
LastLogEntry
LogColumns
DigitalIOPorts
DigitalInputs
DigitalOutputs
You can find the specified functions under the following path in the address area of a read
point:
● DeviceSet > Readpoint_x1 > IOData
● DeviceSet > Readpoint_x1 > RuntimeParameters
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 06/2019, C79000-G8976-C512-02
Various information on the last successful transponder access or command
Client interface via which the last transponder access took place.
Command that was executed during the last transponder access operation.
Transponder which was accessed with the last command.
Time of the last transponder access
Read/written data of the last command.
Only possible with commands for reading/writing the transponder memory.
Antenna via which the transponder was accessed with the last command.
Power with which the last command was executed on the transponder.
This function is only supported by UHF readers.
Protocol Control Word of the transponder that was accessed last.
This function is only supported by UHF readers.
Polarization with which the last command was executed on the transponder.
This function is only supported by UHF readers.
RSSI value with which the last command was executed on the transponder.
This function is only supported by UHF readers.
Various log information.
The last entry in the log.
The headers column of the log as formatted string
Digital IO ports
Digital inputs of the communications module
This function is only supported by the CI variants of the communications mod-
ules.
Digital outputs of the communications module
This function is only supported by the CI variants of the communications mod-
ules.
Programming via the OPC UA interface
9.1 Supported methods/functions
105