Camera Menu - Fluke Ti300 PRO User Manual

To use the distance measurement feature:
1. Turn on the distance feature and select the units to show on the display.
2. Point the Imager at the target.
3. Pull and hold the Secondary Trigger.
* shows at the top of the display.
4. Position the red laser dot on the target.
5. Release the Secondary Trigger.
The distance measurement shows on the bottom of the display. The measurement shows as "- - - -" when
the Imager cannot take a measurement. If this is the case, use a tripod or steady the Imager and retake the
measurement. If there is excessive laser movement, an error message shows on the display due to an out of
range distance.

Camera Menu

Table 12 lists the options in the Camera menu.
Option Menu
On
LaserSharp
Autofocus
Off
Backlight <options>
Torch --
Video/Audio
Video Video ONLY
Record Video
Table 12. Camera Menu
Option
Turns on LaserSharp Autofocus to automatically focus on a target.
LaserSharp Auto Focus
See
Turns off LaserSharp Autofocus to use the Advanced manual focus.
LaserSharp Auto Focus
See
Select to set the brightness level of the display.
Turns on/off the built in flashlight.
Select to record video and audio when Record Video is selected.
Select to record video only when Record Video is selected.
Select to start recording a video. See Video.
Professional Series Thermal Imagers
Description
System.
System.
Menus
23