HP DesignJet 750C Plus Quick Reference Manual page 11

Scroll until the display shows the type of media you are loading*,
and then press the
Enter
SELECT MEDIA
Opaque bond
The plotter checks the sheet's size and alignment, then advances it to
the start of the page. When loading is complete, the
" " screen is displayed.
STATUS / Ready
*For advice on media types, see page 12.
If you have difficulty in loading a sheet, see the "Troubleshooting"
section in the User's Guide.
To Load Media the Right Way Up
Media Type
Opaque bond
Translucent bond
Natural tracing paper
Vellum
Coated paper
Heavy coated paper
Matte film
Clear film
High-gloss photo paper*
Semi-gloss photo paper*
High-gloss film*
*These media types are not supported by the HP DesignJet 700 plotters
C4705A and C4706A.
All manuals and user guides at all-guides.com
key.
Enter
Media-Loading Tips
Both sides are the same. If the sheet is
curled, load with the convex (hollow) side
toward you.
Load with the coated side underneath.
On HP Coated Paper and Heavyweight
Coated Paper, look for the small notch in
the corner:
When loading in portrait orientation,
make sure the notch is on the right side
of the leading edge.
When loading in landscape orientation,
make sure the notch is on the left side
of the leading edge.
Load with the matte side underneath.
Load with the rougher side underneath.
Load with the glossy side underneath.
9
0014