Table of Contents
Advertisement
IPIMG=xxx.xxx.xxx.xxx: nnnn
Destination IP address of image data: Configure the port number.
Sends reading results from the TCP server when the destination IP address is
0.0.0.0.
Sends reading results from the TCP client when the destination IP address is
other than 0.0.0.0.
xxx.xxx.xxx.xxx
nnnn
Destination port nimber (1 to 63335)
RTIME=<Connection request interval>
Set the interval time that the TCP client communication attempts to reconnect to
0 to 100 seconds.
When the interval time is 0, Code Reader connects every time when you send
data.
When the interval time is other than 0, Code Reader connects automatically (at
the same time the reader is powered on).
This configuration change is enabled at the next connection.
STOUT=<Duration time>
Set the interval time that Code Reader requests a disconnection in 0 to 100
seconds after the lost of data to transmit and receive from the TCP client.
When the interval time is other than 0, Code Reader does not send the
disconncetion request.(Always-on connection).
TCPCS=a (a=0; Disable
Set the function of data arrival confirmation. If enabled, the reader will wait to
send the next data until receiving "Ack", which is associated with the previous
data, from the host.
?who
Get the following status: .
Local IP address (IP address of the reader)
Local port number (TCP server port number of the reader)
Subnet mask
Deffault gateway
MAC address (last 3 bytes)
Destination IP address
a=1; Enable)
76
Advertisement
Table of Contents
