Advertisement
OPERATION
Initial Startup:
After satisfying the installation requirements, the Lettuce Dispenser is ready to operate. The unit will start when the Power Cord is
connected to a live electrical receptacle. If the Compressor and Condenser Fan are not running when the unit is initially plugged in,
check to make sure that the Temperature Control is not set to the 'off' position. Allow the unit to run a minimum of one (1) hour before
loading it with product.
Temperature Control
The Electronic Temperature Control is located on the front of the unit. To check the temperature control set point, push and release
the 'set' button on the control and the display will show the set point temperature. To adjust the set point, push and hold the 'set'
button until display blinks, then push the up or down arrows to adjust the set point. Either press the 'set' button again or wait 10
seconds and the control will store the new set point. Allow the unit a minimum of one hour to respond to a control setting adjustment.
Defrost:
The Lettuce Dispenser is a manual defrost unit. The unit should be defrosted whenever the walls accumulate a frost/ice bank that is
1/2 inch thick. To defrost the unit, first remove the Lettuce Bin from the unit then disconnect the Power Cord from the electrical
receptacle, and open the Door. After the frost/ice has melted or come loose from the cabinet walls, wipe out the cabinet interior with
a dry cloth or sponge. Do not attempt to scrape or chisel off the frost/ice as you could do irreparable damage to the cabinet.
MAINTENANCE
Preventative maintenance is minimal although these few steps are very important to continued operation and maximizing the life of
the appliance.
Cabinet Surfaces:
The interior and exterior surfaces are stainless steel and should be cleaned periodically with a solution of warm water and a mild soap
and wiped dry with a clean soft cloth. Should a surface become stained or discolored, do not attempt to clean with an abrasive cleaner
or scouring pad. Use a soft cleaner and rub with the grain of the metal to avoid scratching the surface.
Condenser
Periodically, dust on the condenser coil must be cleaned. The condenser is located behind the front cover at the right front of the
unit. Remove the front cover by pulling on the bottom edge of the cover. The condenser will be exposed. Clean the accumulated
dust/debris from the condenser with a vacuum or brush or chemical cleaning agent (Nu-Calgon 4171-75 or equivalent). This will
need to be done regularly to maintain the compressor warranty!
WARNING: The condenser fins are very sharp, use caution when cleaning the condenser.
Door Gasket:
To extend the life of the door gaskets, clean them regularly by wiping them with a solution of warm mild soapy water and rinse with
clean water.
MODEL
SERIAL NO.
DATE INSTALLED
3
Advertisement
