Table of Contents
Advertisement
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to power. The
specifications on the data plate supersede any future discussion.
The standard refrigerated display case is equipped with an eight (8) foot power cord that requires a 115 Volt, 60 Cycle, 1 Phase
properly grounded electrical receptacle. The power cord comes with a 3 prong plug for grounding purposes. Any attempt to cut off
the grounding spike or to connect to an ungrounded adapter plug will void the warranty, terminate the manufacturer's responsibility
and could result in serious injury.
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit and not plugged into an
extension cord.
OPERATION
Initial Start Up
After satisfying the installation requirements, the display case is ready to start. The display case will start when the power cord is
connected to the required power source. If the compressor does not start when the unit is initially plugged in, check to make sure
that the Temperature Control is not in the "off" position. Allow the unit to run for two hours before loading it with product. When
loading the unit with product, take care not to block the air flow at the end of the cabinet as this would affect the unit's performance.
Temperature Control
The Temperature Control is located on the compressor end of the cabinet and is factory set to maintain an average cabinet
temperature of approximately 37 Deg. F. To obtain colder temperatures, press and hold the set button until the set point value
flashes. Use the up or down arrow buttons to change the value and then press the set button again. Allow the unit a minimum of
one hour to respond to a control setting adjustment.
Lights
There is an on/off switch for the lights on the right front end of the light shroud.
Defrost
Your Silver King refrigerator is an automatic defrost unit and no additional plumbing is required. Automatic defrosting is
accomplished when frost buildup on the Evaporator Coil is cleared during Compressor "off" cycles. Defrost water is collected in a
pan located in the compressor compartment where it is evaporated into the room air. It is important that the unit be installed level or
tilted slightly backwards to allow proper drainage of the condensate water
MAINTENANCE
Preventative maintenance is minimal although these few steps are very important to continued operation and maximizing the life of
the appliance.
Cabinet Surfaces
The cabinet exterior is stainless steel and interior is aluminum. These surfaces should be cleaned periodically with a solution of
warm water and mild soap, rinsed and wiped dry with a soft cloth. Should a surface become stained, do not attempt to clean with
an abrasive cleanser or scouring pad. Use a soft cleanser and rub with the grain of the metal to avoid scratching the surface. Do
not use caustic cleaners on the stainless steel.
Condenser
Periodically, dust will collect on the condenser coil and must be cleaned. The condenser is located behind the end cover at the right
side of the unit. Remove the end cover by removing the six screws securing the cover. The condenser will be exposed. Clean the
accumulated dust/debris from the condenser with a vacuum or brush or chemical cleaning agent (Nu-Calgon 4171-75 or
equivalent). This will need to be done regularly to maintain the compressor warranty!
WARNING: The condenser fins are very sharp, use caution when cleaning the condenser.
Doors
The roller wheels on the Doors should be examined regularly to insure they spin freely. If the wheel bearings become sticky they
should be lubricated with a penetrating lubricant. Do not use a lubricant that is sticky and will buildup.
MODEL
SERIAL NO.
3
DATE INSTALLED
Advertisement
Table of Contents
