KTM 250 EXC-F EU 2013 Setup Instructions page 8

2 SETUP
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
–
Install the front fender. (
–
Refit the headlight mask with the headlight. (
–
Install the front wheel. (
–
Correctly mount the fuel tank breather.
C00111-10
–
Secure the handlebar cushion with two cable binders.
601710-01
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Pliers for footrest spring (58429083000)
101019-01
–
Mount the license plate holder with the license plate lamp, turn signals, and reflec-
tor.
–
Connect the electrical components.
–
Connect the connector of the left turn signal with connector that is marked red.
–
Connect the connector of the right turn signal with the connector that is marked
green.
601711-01
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
–
–
–
–
101393-12
–
Fill the battery.
Info
Read the notes in the battery package.
–
Charge the battery. (
–
Install the battery. (
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying KTM PowerParts installation instructions.
p. 11)
p. 10)
Keep batteries out of the reach of children.
Wear suitable protective clothing and goggles.
Avoid contact with battery acid and battery gases.
Keep the battery away from sparks or open flames. Charge only in well-
ventilated areas.
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
p. 12)
p. 11)
p. 9)
6