KTM 250 EXC-F EU 2013 Setup Instructions page 6

2 SETUP
(XCF‑W)
–
Insert the indicator lamp with the brown/red and yellow/blue cable colors
into socket
–
Insert indicator lamp LED with the white and orange cable colors into
socket
–
Connect pull switch
C00115-10
(All EXC‑F models)
–
Attach the retaining bracket for the connector, the turn signal bracket with
the turn signal, and the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis
401380-01
(XCF‑W)
–
Attach the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis
401381-01
(All EXC‑F models)
–
Mount and tighten nuts
–
Connect connector
marked green.
–
Connect connector
marked red.
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
601705-10
(XCF‑W, EXC‑F EU, EXC‑F AUS)
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp
Screw, bottom triple clamp
601707-10
(EXC-F SIX DAYS)
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp
Screw, bottom triple clamp
.
3
.
4
with the yellow and white cables.
5
of the turn signals on both sides.
6
of the right turn signal with connector
7
of the left turn signal with connector
9
Info
The topmost milled groove in the fork leg must be flush with the top
edge of the upper triple clamp.
Position bleeder screws
bl
M6 10 Nm
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
8
bk
M8 20 Nm
(14.8 lbf ft)
M8 15 Nm
(11.1 lbf ft)
toward the front.
M8 17 Nm
(12.5 lbf ft)
M8 12 Nm
(8.9 lbf ft)
4
, which is
, which is