Table of Contents
Advertisement
3
WORK
3.9
Installing the front fender
3.10
Removing the seat
3.11
Mounting the seat
3.12
Installing the battery
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Make sure the holding lugs engage in the start number plate or headlight
mask.
101345-10
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
101346-10
–
Hook in the front of the seat at the collar sleeve of the fuel tank, lower it at the rear
and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis
101347-01
Main work
–
Insert battery into the battery compartment with the terminals facing to the front.
Battery (YTX4L-BS)
–
Reconnect rubber band
–
Connect positive cable
Guideline
Screw, battery terminal
Info
Contact disk
with the claws facing down.
–
Slide positive terminal cover
–
Connect negative cable
Guideline
Screw, battery terminal
101645-10
Info
Contact disk
with the claws facing down.
.
1
.
1
.
2
must be mounted between screw
A
over the positive terminal.
6
.
3
must be mounted between screw
A
.
1
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
M5
2.5 Nm
(1.84 lbf ft)
and cable socket
4
M5
2.5 Nm
(1.84 lbf ft)
and cable socket
4
11
5
5
Advertisement
Table of Contents
