Table of Contents
Advertisement
2
SETUP
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws.
Guideline
Screw, handlebar clamp
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
C00108-10
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
C00110-10
(All EXC‑F models)
–
Mount the turn signal switch.
401382-01
Info
The rebound damping is located in the right fork leg (red adjust-
ing screw). The compression damping is located in the left fork leg
(white adjusting screw).
The topmost milled groove in the fork leg must be flush with the top
edge of the upper triple clamp.
Position the bleeder screws toward the front.
M8
20 Nm
(14.8 lbf ft)
5
Advertisement
Table of Contents
