Engine Installation; Engine Swing Lockout Instructions - Peco Estate 795003 Operator's Manual

Engine Installation

First, place (2) Rubber Shock Absorber (Item #3) on top of the Engine Mount Assembly (Item #2) aligning the bolt
holes. Next, position the Engine Assembly (Item #1) on top of the Shock Absorbers aligning the bolt holes of all the
parts. Finally, secure the Engine by using (4) 5/16"-18 x 2" HHCS (Item #4) and (4) 5/16"-18 Nyloc Nuts (Item #5).
Refer to Figure A.
Note: Estate Series shown below. Some parts and part features have been hidden from view for visual clarity.
Figure A

Engine Swing Lockout Instructions

Estate Series Unit Instructions
First, remove the Lower Hose from the Blower Cone on the Engine Assembly. Then, swing the Engine Support Arm
Assy towards the center of the Tongue Assembly and lower the Adjustable Jack Assembly until the Trailer Vac is
slightly elevated and the Hitch Pin, securing the Trailer Vac, can move freely. Next, Align the top and bottom Engine
Swing Arm Lockout Brackets and finally, secure the (2) Engine Swing Arm Lockout Brackets together using the Hitch
Pin Assembly (Item #1) and Hair Pin Cotter (Item #2). Refer to Figure B & C.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure B Figure C
29