Table of Contents
Advertisement
Vertical Rail Assembly Installation
Position the Right Vertical Rail Assembly (Item #2) onto the right Side Panel aligning all bolt holes to those of the Side
Panel. For this step, the top (2) bolt holes will remain open and not use any hardware.
Secure the Right Vertical Rail Assy relatively loose by using (3) 5/16"-18 x 3/4" Carriage Bolt (Item #3) and (3) 5/16"-
18 Flange Nut (Item #5) on the middle (3) bolt holes. Then use (1) 5/16"-18 x 3/4" HHCS (Item #4) and (1) 5/16"-18
Flange Nut (Item #5) on the lower bolt hole. Refer to Figure A.
Repeat the same procedure for the Left Vertical Rail Assembly (Item #1). Make sure all hardware are secured
relatively loose.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure A
Left
Right
10
Advertisement
Table of Contents
