Switching Motor On And Off; Motor Speed Control - Euroboor ECO.60S+ User Manual

When the electromagnet is not able to create a good enough magnetic field, this may be caused by
- Surface not being flat;
- Workpiece is not magnetisable (e.g. aluminium);
- Workpiece is coated or painted;
- Workpiece is not thick enough;
In this situation the magnet indicator will light up red. Make sure to solve any of these matters
before proceeding in any way and creating unsafe situations.
Using the magnet:
1. Place and position the machine on the workpiece;
2. To activate the magnet, press the red magnet switch:
The magnet switch will be lit (red);
The LED indicator lights up GREEN when generated magnetic force is sufficient;
3. To deactivate the magnet, press the same switch again.
WARNING: Do not use this machine when LED indicator is RED. Magnet may not generate
sufficient attachment force.
We want to point out that above mentioned precautions and indicators do not guarantee that the
magnet will not release from the material. Euroboor accepts no liability when it comes to the
magnet indicator not functioning or functioning poorly.
Make sure that the magnet attaches tightly to the work piece before turning on the motor unit of the
magnetic drilling machine. Euroboor magnets have two coils; make sure that both coils are in contact
with the material. Do not connect any other machine to the same electrical outlet to which the
magnetic drilling machine is plugged into, as it may result in the loss of magnetic force.
Always use the safety chain included. Drilling above your head is extremely dangerous and is not
recommended. For the use of magnetic drilling machines on pipes, not-flat or non-magnetic
materials, we refer to our catalogue or our website
tightening systems, pipe clamping systems and Tube machines can be found.

4.5 Switching motor on and off

The motor unit can only be switched ON when the magnet is activated. To switch the motor ON,
press the green button with marking "I". To switch the motor OFF, press the red button with marking
"O".

4.6 Motor speed control

The RPM dial allows you to electronically control the speed of the motor (in both clockwise and
counter clockwise direction).
- The indicator of the RPM dial in bottom left corner is minimum speed;
- The indicator of the RPM dial in bottom right corner is maximum speed.
The electronic motor speed control works for both mechanical gears. Be careful not to overturn the
dial.
www.euroboor.com
19
where several vacuum