Preparation & Adjustment; Assembly - Euroboor ECO.60S+ User Manual

3. Preparation & adjustment

3.1 Assembly

WARNING: To reduce the risk of injury, turn machine off and disconnect from power source
before installing and removing accessories, before adjusting or changing set- ups or when
making repairs. Be sure all switches are in the OFF position. An accidental start-up can cause
injury.
Fitting the feed handles
1. Fit each of the three feed handles by screwing them into the hub in clockwise direction.
2. Tighten firmly by hand.
The handles are supposed to face slightly outward. Be careful not to cross-thread any of the
components.
Mounting the safety guard
The safety guard protects against chippings and accidental contact and must always be mounted
before operation.
1. Hold the guard in front of the magnet, align the slots in the guard with the holes in the
magnet.
2. Fit the screws into the holes located in the side of the magnet.
WARNING: Always use the safety guard.
Fitting the lubrication system
The lubrication system can only be used for horizontal drilling (the drill being used vertically).
In order to use the lubrication system, it must be filled with a sufficient amount of cutting fluid.
1. Make sure the flow regulator is closed;
2. Unscrew the cap;
3. Fill the container with cutting fluid;
4. Screw the cap back on.
WARNING: Do not use the lubrication system in vertical or overhead drilling applications.
Instead use Euroboor cutting paste.
1. Hang the tank (A) on the tank holder;
2. Position and tighten the attachment pin (B);
3. Connect the hose (C) to the fitting on the Morse taper
spindle. Make sure the hose is connected fully and
tightly;
4. To disconnect the hose, press the blue ring on the
connection and gently pull out the hose.
[image 3-1]
13