Morse Taper Spindle; Gearbox - Euroboor ECO.60S+ User Manual

4.2 Morse taper spindle

1. Make sure the inside of the output shaft and the Morse taper spindle are clean and free of
grease;
2. Align the lubricator ring rotation limiter with the recess in the gearbox (A);
3. Firmly slide the Morse taper spindle into the output shaft by hand (B). Make sure the spindle
is properly positioned. You should not be able to pull it out by hand;
4. To remove the Morse taper spindle:
- Switch of the motor;
- Rotate the mechanical gear switch to neutral (see paragraph 4.3 Gearbox);
- Rotate the output shaft until the slots on the shaft align with the slots on the gearbox;
- Gently tap the supplied drift into the slots to push the Morse taper arbor out.

4.3 Gearbox

1. To select the correct gear from neutral (horizontal) position:
a. Rotate the switch counter clockwise to position o, this is gear 1;
b. Rotate the switch clockwise to position oo, this is gear 2;
2. A gear is only correctly selected when the gearbox switch is aligned with the indicators on
the gearbox;
In case you have trouble fully and correctly selecting a gear, the gears in the gearbox might be
misaligned. Slightly rotating the output shaft by hand will help you align the gears correctly and fully
select the intended gear.
[image 4-2]
17
[image 4-3]