Table of Contents
Advertisement
12.
Select [Auto send].
Once [Enable] is set, images are automatically sent when you turn the
camera on.
13.
Restart the camera.
The images are now sent automatically.
To switch networks, select [Switch network] and follow steps 5–8.
To remove the connection, select [Clear camera web link settings] and then [OK].
Note
All image files on cards are sent when [Auto send] is set to [Enable].
When [Auto send] is set to [Enable], auto send starts after the camera starts up
(or recovers from auto power off).
Any images captured during auto sending are also sent.
Caution
Auto send does not start during interval timer shooting.
Transfer stops in the following cases.
• [Airplane mode] is set to [On]
• A USB connection is started
• Battery capacity is low
• The camera's power switch is set to <
>
536
Advertisement
Table of Contents
