HT11K Hand Tool NANOMQS 0.13-0.35 SQ.MM
2.2.1
Instructions
Instructions are marked as follows:
For action steps
For action results
2.2.2
Notes
2.3
Abbreviations
Abbrevia-
tion
TE P/N
3
General Safety Instructions
The hand tool has been manufactured in line with current industry standards and recog-
nised safety rules.
Nonetheless, a risk of physical and material damage exists if the following general safety
instructions and warnings preceding the instructions in these operating instructions are
not followed.
Finding information about RoHS
Information on the presence and location of substances subject to Restriction of Hazard-
ous Substances (RoHS) guidelines can be found on the following website:
http://www.te.com/en/resources/product-compliance.html
Click on the entry field underneath Test Product Compliance and Request State-
ments of Compliance (SoCs) and enter the relevant item numbers.
Click on the entry field underneath Product Compliance and enter the relevant part
number(s).
Click on the Search button.
The search results will be displayed.
3.1
Intended Use
The hand tool is used to crimp NanoMQS terminals according to the TE processing speci-
fication and drawing listed in Table 3.
The hand tool may only be used for repair purposes or for making samples, not for series
production.
OPERATING INSTRUCTIONS
411-18608-1_Rev.A
General note on operation/use.
Meaning
TE Connectivity part number
Table 2: Abbreviations used
Page 3 - 9