Engine Oil And Oil Strainer - Yamaha MIO AL115S 2010 Owner's Manual

TIP
_
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4–1/2 turn
past finger tight. However, the spark
plug should be tightened to the speci-
fied torque as soon as possible.
_
4. Install the spark plug cap.
5. Install the panel.
PERIODIC MAINTENANCE AND ADJUSTMENT

Engine oil and oil strainer

The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil strainer
cleaned at the intervals specified in the
periodic maintenance and lubrication
chart.
To check the engine oil level
1. Place the vehicle on the center-
stand. A slight tilt to the side can
result in a false reading.
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Wait a few minutes until the oil set-
tles, remove the oil filler cap, wipe
the dipstick clean, insert it back
into the oil filler hole (without
screwing it in), and then remove it
again to check the oil level.
7-9
EAUU0342
ZAUU0053
1. Oil filler cap
TIP
_
The engine oil should be between the
minimum and maximum level marks.
_
ZAUU0054
1. Dipstick
2. Maximum level mark
3. Minimum level mark
7