Address Switch; Address Setting Of The Remote Control Unit - Sanyo 09KHS71 Installation Instructions Manual

05-423 KHS0971-1271 12/13/05

8. Address Switch

8-1. Address Setting of the Remote Control Unit

The address can be set in order to prevent interference
between remote controllers when two Sanyo indoor units
are installed near each other. The address is normally
set to "A." To set a different address, it is necessary to
change the address on the second remote controller.
NOTE
Once changed, you cannot restore the original address
setting of the air conditioner.
(1) Switch on the power source.
(2) Break the address-setting tab marked "A" on the
second remote controller to change the address
(Fig. 62). When the tab is removed, the address is
automatically set to B (Fig. 63).
(3) Press and hold the remote controller ION button and
1 HR TIMER button. At the same time, press the
ACL(reset) button. Use a thin object such as the tip
of a pen to press the ACL button. When this has
been done, "oP-1" (test run) appears, blinking, in the
remote controller clock display area.
(4) Each time the 1 HR TIMER button is pressed, the
display changes as shown below. Press this button
2 times to change the display to "oP-7" (address
setting). (Fig. 64)
Test run mode
Selfdiagnostic mode
Adress setting mode
(5) "oP-7" has now been selected for address setting.
(6) Press the ON/OFF operation button on the remote
controller. (Fig. 64) Check that the "beep"signal-
received sound is heard from the second indoor unit
(approximately 5 times). The sound you hear is the
signal that the remote controller address has been
changed.
(7) Finally press the remote controller ACL (reset) but-
ton to cancel the blinking "oP-7" display.
(Fig. 64)
Changing of the second remote controller address is
now completed.
1:23 PM Page 24
Tab
ION
button
24
Fig. 62
ACL button
Fig. 63
ON/OFF
operation
button
1HR.
TIMER
button
ACL
A
(Reset)
button
Fig. 64