Figure 11. Loosen and remove the screws
Screw specifications
3
M2.0 x 4
Step 3.
Release the EDP cable from the cable guides of the fan. Then remove the heat sink and fan
assembly.
Figure 12. Remove the heat sink and fan assembly
Remove the M.2 solid-state drive
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the battery pack" on page 31
Step 1.
Remove 1 screw.
Number of screws
2
.
Chapter 4
Removing a FRU or CRU
35