Frank bSteam bS35 VAC Operating Instructions Manual page 28

Make sure that the push button (18) and the switches (19-20) on the handle (21) are
not switched on.
➢ Press the main switch (10) to switch on the appliance and press the second resistor
switch Boiler switch (11) to heat up the boiler, switch on the appliance and the
boiler.
➢ Press the accessory switch (12) to switch on the steam and suction function.
➢ Wait until the boiler has reached the operating pressure. When the green light (8)
lights up, the appliance is ready for operation.
Adjust the steam quantity using the steam regulator (14).
Adjust the suction power using the control dial (13).
NOTICE:
The suction power and the amount of steam can be changed during use. During normal
use, the green light indicates that the pressure in the boiler is at the normal value;
however, if steam is constantly being produced, the pressure in the boiler drops and
the green light goes out automatically until the operating pressure has been reached
again. In this condition, work can continue calmly, as the resistors are dimensioned in
such a way that the operating pressure can be restored shortly.
Switch on the suction function:
Make sure that the switch (19) on the handle (21) is not turned on. Press the main
switch (10) and the accessory switch (12) to switch on the appliance as a vacuum
cleaner; the appliance is now ready for use.
Adjust the suction power using the control dial (13).
Mode of operation:
Before using the device, connect the desired accessory to the handle of the working
hose (21). After the accessories are mounted, all controls for operation are located on
the handle.
Via these controls can:
Steam can be generated by pressing the red push button { 18);
➢
-Press the blue switch (19) to switch on the suction function;
➢
-by pressing the switch (20) chemicals or water can be sprayed;
➢
by pressing the red push button ( 18) and the switch (19) at the same time, steam
➢
can be generated and extracted at the same time.
by pressing the red push button ( 18) and the switch (20) simultaneously, steam is
➢
generated and chemicals are sprayed at the same time.
SWITCH ON STEAM VACUUM CLEANER
10