Frank bSteam bS35 VAC Operating Instructions Manual page 23

Fill boiler:
Fill the bottle with water whose dH is between 5° and
15° dH must be included. (Fig. 2)
NOTICE:
Do not use demineralised water or water that is too acidic, see condition Application of
warranty. Open the filler neck(9) by hand; pour the water into the filler opening. When
the tank is completely full, close the cap again. (Fig. 3)
When there is no more water in the water tank,
the appliance will continue to emit steam for 4 minutes
after the beep, there will be no more steam...
until the tank has been refilled with water.
Do not fill the boiler with chemicals; this
could damage it permanently.
Fill container for chemicals:
Filling with tap water or non-foaming water
cleaning agents into the respective tank by lifting
of the cover (15). (Fig. 4)
IMPORTANT: Only use cleaning agents that are approved by
Sanivap be recommended. It is absolutely forbidden to use strong
use acidic, strongly alkaline or oxidizing agents.
Fill the waste water tank:
To ensure proper suction, 2.5 L
Pour water into the waste water tank (2).
This filters the air and removes the dirt particles.
(dust, germs, etc.) remain in the container.
Do not exceed the maximum quantity indicated.
(Fig. 5)
Fig. 2
Fig. 3
Fig. 4
Fig. 5
5