Starting Warm Engine; Stopping Engine - Echo Power Pruner PPT-265ES Operator's Manual

sTarTIng warm engIne

The starting procedure is the same as Cold Start except DO NOT close
the choke.
WARNING
The attachment should not move at idle, otherwise serious personal
injury may result.
NOTE
If attachment moves, readjust carburetor according to "Carburetor
Adjustment" instructions in this manual or see your ECHO Dealer.
Stop Switch.
1.
Move Stop Switch button (A) forward away from the STOP posi-
tion.
2. Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter.
Lay the unit on a flat, clear area and firmly grasp throttle handle
with left hand. Do not depress throttle trigger. Pull the recoil
starter handle (D) until the engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.

sToppIng engIne

1. Throttle.
Release throttle trigger, and allow engine to return to idle before
stopping engine.
2. Stop Switch.
Move stop switch button (A) backward to STOP position.
WARNING
If engine does not stop when stop switch is moved to STOP posi-
tion, close choke - COLD START position - to stall engine. Have
your ECHO dealer repair stop switch before using pruner again.
P P
ower
o '
PeraTor s
A
Cold Start
Run
C
A
TM
runer
19
M
anual
D