Starting Warm Engine; Stopping Engine - Echo Power Pruner PPF-210 Operator's Manual

16

STARTING WARM ENGINE

The starting procedure is the same as Cold Start, except DO NOT close
the choke, and do not depress throttle trigger.
WARNING
The attachment should not move at idle, otherwise serious personal
injury may result.
NOTE
If attachment moves, readjust carburetor according to "Carburetor
Adjustment" instructions in this manual or see your ECHO Dealer.
1. Stop Switch
Move stop switch (A) forward away from the STOP position.
2. Primer
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Lay the unit on a flat, clear area and pullthe recoil starter handle
(D) until the engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.

STOPPING ENGINE

1. Throttle
Release throttle and allow engine to return to idle before shutting
engine off.
2. Stop Switch
Move stop switch (A) backward to STOP position.
WARNING
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using pruner
again.
DANGER
DANGER
A
D
A