Table of Contents
Advertisement
Setting DRC
You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.
MAIN UNIT
1
2
3
To Exit Setup Mode
Wait for about 5 seconds or turn the VOLUME CONTROL of the main unit.
•
"SETUP MODE OFF" appears on the display and exits Setup Mode.
Setting DRC
STD : Set DRC effect to standard.
•
MAX : Set DRC effect to maximum.
•
MIN : Set DRC effect to minimum.
•
21
(Dynamic Range Compression)
√
Press and hold SURROUND button for about 5 seconds.
"SETUP MODE" appears on the display and enters into Setup Mode.
•
Press INPUT button 3 times.
"DRC SETUP" appears on the display.
•
Press SURROUND button to set DRC.
Each time you press this
•
button, DRC : STD
MIN
selected in turn.
Caution!
This function operates only in main unit.
•
Test Tone
Use test tine to check speaker connection status or defect of speaker or adjust the level.
DRC :
DRC : MAX will be
To Automatically Output Test Tone
√
REMOTE CONTROL
1
Press TEST TONE button.
•
Test signal will be automatically output as follows; F.L
S.B
S.L
S.W.
During test tone output, press ...† button to adjust the speaker output level
•
from -10 to +10 dB by 1 step.
To Stop Test Tone
Press TEST TONE button again.
•
Caution!
You cannot use test tone in 5.1CH MULTI CH function.
•
CEN
F.R
S.R
22
Advertisement
Table of Contents
