Humanscale eFloat Go 2.0 Installation Manual page 4

When using an electrical furnishing, basic precautions should always be followed, including the
following:
Read all instructions before using (this furnishing).
– To reduce the risk of electric shock:
1. Always unplug this furnishing from the electrical outlet before cleaning or servicing.
– To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Unplug from outlet before putting on or taking off parts.
2. Close supervision is necessary when this furnishing is used by, or near children, invalids, or
disabled persons.
3. Use this furnishing only for its intended use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
4. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water. Return the furnishing to a service center for
examination and repair.
5. Keep the cord away from heated surfaces.
6. Never operate the furnishing with the air openings blocked. Keep the air openings free of lint, hair,
and the like.
7. Never drop or insert any object into any opening.
8. Do not use outdoors.
9. Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
10. To disconnect, turn all controls to the off position, then remove plug from outlet.
11. For loading always put heavier items at the bottom and not near the top in order to help prevent
the possibility of the furnishing tipping over.
12. The table is not complete until mated with a work surface, mount only approved work surfaces in
accordance with instructions. Failure to do so may cause instability, collapse, or failure of electrical
components.
13. For Indoor Use Only.
14. Not to be used in locations where children, or people with cognitive disabilities are anticipated to
be present.
15. Review the assembly instructions to confirm that the appropriate critical components and
accessories are being used with the furnishing.
16. Disconnect from supply circuit before clearn and maintance.
17. Risk of fire and shock, Use only NISPT-2 type 18 AWG cord.
18. The table top must have a flame rating of 200 or less and smoke rating of 450 or less. Any other
material should be evaluated with the table frame to determine its acceptability.