ProfiTap XX Series Quick Start Manual

QUICK START GUIDE
1
CAREFULLY UNPACK ALL THE ITEMS AND RETAIN THE PACKAGING FOR LATER USE
XX-1800G is shipped with the following items:
XX-1800G main unit
2 x C13 AC power cord
1 x mini USB to RJ45 female serial cable
1 x RJ45 female to 9-pin serial adapter
2
CONNECTING POWER & START UP
A
Power on the device by connecting the included AC power cord(s) to device and main power.
B
The unit starts up and boots once it is powered. You can follow its status by observing the activity LEDs.
C
BOOT SEQUENCE (~40 SECS)
Stage 1 (~35 secs):
Stage 2 (~2 secs):
Stage 3: PSU1, PSU2, FAN, STAT LEDs green
D
NORMAL OPERATION MODE
PSU1, PSU2:
FAN, STAT: Green
XX-1800G
PSU1 PSU2 FAN STAT
2 4 6
1 3 5 7
3
INITIAL SETUP OVER SERIAL CONNECTION
XX-1800G features a serial management port, located on its front panel [1]. Connecting through this port allows the users to make the
initial setup on the device, adding new users and enabling its network interface.
A
Connect the XX-1800G serial administration port to a computer, using the supplied cable and adapters.
B
Use the following settings when connecting to the device: 115200 baud rate, 8 bit, no parity, 1 bit stop.
C
Login, using the following initial credentials:
Default name: profitap
Default password: profitap
D
Follow the prompt to create an administrator account. After creating the new admin account, the session will close. The
factory default user (profitap) remains active for direct connections to the unit's serial management port.
E
(Optional) Login with the newly created admin account, and manually enable the network interface (using the
system.network.set command) for the unit to become accessible remotely via web and SSH.
1 x rack mounting kit (front brackets, rear brackets,
and the necessary screws)
4 x rubber foot with adhesive patch
PSU1, PSU2, FAN, STAT LEDs off, fans at full speed
PSU1, PSU2, FAN, STAT LEDs orange for 2 secs, fans at normal speed
Green if present and operational, yellow if absent or inoperational
8 10 12 14 16 18 20 22
9 11 13 15 17 19 21
24 26 28 30 32 34 36
23 25 27 29 31 33 35
XX-1800G is designed to be rack
mounted. Make sure the unit is
properly grounded and secured in
the rack using the included screws
and pre-mounted brackets.
PSU1
2
1 3
38 40 42 44 46 48 50
37 39 41 43 45 47 49
XX-1800G
XX-1800G
PSU2 FAN STAT
4 6 8
5 7
[1] [2]
52 54
51 53
9