Yamaha NEO'S 4 2008 Owner's Manual page 43

2 3
1
1. Engine oil drain bolt B
2. Strainer
3. Compression spring
4. O-ring
4. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the oil strainer, compres-
sion spring, O-ring and engine oil
drain bolt B.
TIP
Make sure that the O-ring is properly
seated.
7. Install engine oil drain bolt A, and
then tighten both drain bolts to
their specified torques.
PERIODIC MAINTENANCE AND ADJUSTMENT
Tightening torque:
4
Engine oil drain bolt A:
23 Nm (2.3 m • kgf,
16.6 ft • lbf)
Engine oil drain bolt B:
32 Nm (3.2 m • kgf,
23.1 ft • lbt)
8. Refill with the specified amount
of the recommended engine oil,
and then install and tighten the oil
filler cap.
Recommended engine oil:
See page 8-1
Oil change quantity:
0.78 L (0.82 US qt, 0.69 Imp.qt)
NOTICE
G
Do not use oils with a diesel
specification of "CD" or oils of
a higher quality than specified.
In addition, do not use oils
labeled "ENERGY CONSER-
VING II" or higher.
G
Be sure no foreign material
enters the crankcase.
1. Oil filler hole
9. Start the engine, and then let it
ECA11670
10. Turn the engine off, and then
6-10
1
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the
engine off and check for the cau-
se.
check the oil level and correct it if
necessary.
6