Table of Contents
Advertisement
neutral. The machine dynamically brakes to a
stop.
This traction system allows you to customize the
acceleration settings for operator comfort and course
conditions. Refer to
Accessing Protected Menus
(page 27)
for changing the settings.
Figure 46
1. Traction pedal
Using the Virtual Pedal
Stop (VPS) Feature
The virtual pedal stop (VPS) feature allows you to
temporarily set a maximum traction speed that is less
than the password-protected supervisor maximum
traction speed.
To temporarily set the maximum speed of the
machine, press the traction pedal fully forward
46). You can set a separate speed for the mow range
and transport range
(Figure
•
To access this feature, select the InfoCenter
middle button from the main screen
Note:
This feature reverts back to the supervisor
maximum speed settings when the key is switched
off.
g383737
(Figure
47).
(Figure
47).
1. Indicates the maximum
traction speed (pedal stop)
•
This feature allows you to customize the speed
settings for your comfort level, or to customize the
speed settings to fit the application.
Whenever the max traction speed is changed via the
supervisor max speed settings or Virtual Pedal Stop,
the traction pedal is automatically reprogrammed to
use the full pedal stroke between neutral and the
new max speed. This means the operator gains
more precise control of the traction speed at lower
maximum speed settings.
Tips for Using Virtual Pedal Stop
(VPS)
•
Set the max speed temporarily lower for mowing
the cleanup pass on the fairway.
•
Set the max speed temporarily lower for improved
control operating in or near the maintenance shop.
•
Set the max speed temporarily lower for improved
control loading the machine onto a trailer.
Operating the Cruise
Control
Setting the Cruise Control
The cruise-control switch locks in the cruise control to
maintain the desired ground speed. Pressing the rear
of the switch turns the cruise control off, the middle
position of the switch enables the cruise-control
function, and the front of the switch sets the desired
ground speed.
After the cruise control switch is enabled and the
speed is set
(Figure
the speed setting of the cruise control
Figure
49).
To disengage the cruise control use the following:
31
Figure 47
2. This speed is locked out
under the protected PIN
menu.
48), use the InfoCenter to adjust
(Figure 43
g322245
and
Advertisement
Table of Contents
