Exm Menu; Figure 3-11. Exm Menu - HP VXI Pentium 75000 Series Hardware Installation And Configuration Manual

EXM Menu

Option Byte 1:
Option Byte 2:
Caution
42 Using the BIOS Setup Utility
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The fields in this menu allow you to change the settings for the EXM module
in the system. The HP VXI Pentium Controller comes with an HP-22 GPIB
interface module installed in EXM Slot 1 by default. The EXM Menu is
shown below.
PhoenixBIOS Setup - Copyright 1985-95 Phoenix Technologies Ltd.
Main Advanced
EXM Slot 0
ID:
Option Byte 1:
Option Byte 2:
EXM Slot 1
ID:
Option Byte 1:
Option Byte 2:
↑ ↓ Select Item
F1 Help
← → Select Menu
ESC Exit
ID:
This field selects the EXM-ID for the HP-22 GPIB expansion module. The
default is FF for Slot 0 and D9 for Slot 1.
This field selects the I/O address selection for the HP-22. The default is FF,
which corresponds to the I/O address 370-377, 770-777, B70-B77, and
F70-F77. Other possible values are:
250-257, 650-657, A50-A57 and E50-E57
F9
270-277, 670-677, A70-A77, and E70-E77
FB
FD 350-357, 750-757, B50-B57, and F50-F57
To disable the HP-22, enter 00.
This field is set to 00 (disabled/unused).
To configure a second HP-22 card in EXM Slot 0, make sure that
it is not sharing the same I/O address as the first card
pre-installed in EXM Slot 1. For information on configuring a
second card, see the hardware reference manual shipped with
the card.
Power EXM Exit
[FF] <Tab>, <Shift-Tab>, or
<Enter> selects field.
[00]
[00]
[D9]
[FF]
[00]
-/+ Change Values
Enter Select > Sub-Menu F10 Previous Values

Figure 3-11. EXM Menu

Item Specific Help
F9 Setup Defaults
Chapter 3