Table of Contents
Advertisement
Figure 93
1. Cutting edge
2. Curved area
All manuals and user guides at all-guides.com
g006530
3. Wear/slot forming
4. Crack
Checking for Bent Blades
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Rotate the blades until the ends face forward
and backward.
4.
Measure from a level surface to the cutting
edge, position A, of the blades
1. Measure here from blade
to hard surface
5.
Rotate the opposite ends of the blades forward.
6.
Measure from a level surface to the cutting edge
of the blades at the same position as in step
above.
Note:
The difference between the dimensions
obtained in steps
mm (1/8 inch).
Note:
If this dimension exceeds 3 mm (1/8
inch), the blade is bent and must be replaced.
70
EUTRAL
(Figure
94).
Figure 94
2. Position A
4
and
6
must not exceed 3
-
LOCK
g000975
5
Advertisement
Table of Contents
