Table of Contents
Advertisement
DANGER
LPG fuel is extremely flammable and vapors
are explosive.
• In case of fire, take the following steps:
1. If you can safely do so, stop the flow
of gas as quickly as possible. Never
put out the flame unless you can shut
off the gas.
2. Notify the fire department and clear
the immediate area of all people.
3. When the gas flow has stopped, put
out the fire. Usually, when flow of gas
is cut off, fire will automatically stop.
4. If you cannot immediately stop the
gas flow, direct water onto the tanks
to keep them cool, but do not put out
the fire.
• Storage locations and trailers should
be equipped with at least 1 approved
portable fire extinguisher that has a
minimum capacity of 8.2 kg (18 lb) dry
chemical with a B:C rating. Do not use
carbon-tetrachloride extinguishers such
as Pyrene.
Changing the LPG Tank
Change the LPG tank outdoors in a well-ventilated
area.
Important:
Only hand-tighten the tank-connection
fitting. Overtightening by the use of tools may
cause damage. If hand-tightening does not stop
a leak, contact trained and qualified personnel
immediately.
1.
Shut off the machine on level ground, disengage
the blade-control switch (PTO), move the
motion-control levers to the
position, and engage the parking brake.
2.
Wait for all moving parts to stop before leaving
the operating position.
3.
With the engine running, close the fuel valve on
the tank.
4.
Run the engine until it stops.
Note:
This purges all vapors from the hose.
5.
Remove the key.
6.
Carefully disconnect the LPG fuel hose.
All manuals and user guides at all-guides.com
-
NEUTRAL
LOCK
19
Figure 7
1. LPG fuel hose connection
fitting
2. Tank valve
7.
Unlatch the cylinder brackets and remove the
tank.
WARNING
Fuel system components are under high
pressure. Using damaged or improper
components can cause system failure,
fuel leakage, and possible explosion,
which may result in serious injury or
death.
• Do not attempt to repair or modify
the valves, fittings, or other tank
components.
• Use only the Toro-approved LPG tank,
fittings, and hoses that were designed
for your machine.
8.
Inspect the filled tank valve and fitting openings
for dirt, debris, or damage.
9.
Inspect the tank hose connection fitting for
damaged or missing o-rings.
10.
Ensure that the replacement tank type and size
match the tank specification decal.
11.
Align the center hole over the mounting pin that
points straight up on the mower as shown in
Figure
8.
g021497
3. Fuel gauge
4. Safety pressure-relief
valve
Advertisement
Table of Contents
