Remote Control Operation Guide - McQuay MWMX 010FR Instruction Manual

Remote Controller Operation Guide
G7 Remote Controller
1
Transmission source
The source where the signal will
be transmitted
4
Temperature setting
To set the desired room
temperature, press the button to
increase or decrease the set
temperature.
The temperature setting range is
from 16°C to 30°C (Optional
setting 18°C to 30°C).
Press both
simultaneously to toggle the
temperature setting between °C
and °F.
6
Fan speed selection
Press the button until the
desired fan speed is achieved.
7
ON timer setting
Press the SET button will
activate the on timer function.
Set the desired on time by
pressing the SET button
continuously. If the timer is set
to 7.30am, the air conditioner
will turn on at 7.30 sharp.
Press the CLR button to cancel
the on timer setting.
9
Automatic air swing
Press the SWING button to
activate the automatic air swing
function.
To distribute the air to a specific
direction, press the SWING but-
ton and wait until the louver
move to the desired direction
and press the button once
again.
12
Turbo function (optional-only applicable to inverter unit)
Press button for fast cooling or heating operation.
The temperature will be increased internally if it is in the HEAT mode,
decreased if in COOL or DRY mode. Fan speed will be increased if it
is not at maximum speed.
The temperature & fan speed will resume to user setting if the button
is pressed again or after 20mins.
Available under HEAT, COOL & DRY modes only.
buttons
12
10
2
Signal transmission
indication
Blink to confirm the last setting
has been send to the unit.
3
On/Off button
Press once to start the air
conditioner.
Press again to stop the unit.
5
Operation mode
Press the MODE button to
select the type of operating
mode.
For cooling only unit, the
available modes are : COOL,
DRY & FAN.
For heat pump unit, the
available modes are : AUTO,
COOL, DRY, FAN & HEAT.
8
OFF timer setting
Press the SET button will
activate the off timer function.
Set the desired off time by
pressing the SET button
continuously.
Press the CLR button to cancel
the off timer setting.
10
Sleep mode setting
Press the button to activate
sleep mode. This function is
available under COOL, HEAT &
AUTO mode.
When it is activated in COOL
mode, the set temperature will
be increased 0.5°C after 30mins,
1°C after 1 hour and 2°C after 2
hours.
When it is activated in HEAT
mode, the set temperature will
be decreased 1°C after 30mins,
2°C after 1 hour and 3°C after 2
hours.
11
Clock time setting
Press button + or - to increase
or decrease the clock time.