Remote Controller Operation Guide
7) Turbo Function
•
Press
for fast cooling or heating operation.
•
The temperature will be increased internally if it is in HEAT mode, decreased if in COOL and DRY mode.
•
Fan speed will be increased if it is not at maximum speed.
•
The temperature and fan speed will resume to user setting if
•
Available under HEAT, COOL and DRY modes only.
8) ON Timer Setting
•
Press the SET button will activate the on timer function.
•
Set the desired on time by pressing the SET button continuously. If the timer is set to 7.30am, the air
conditioner will turn on at 7.30am sharp.
•
Press the CLR button to cancel the on timer setting.
9) OFF Timer Setting
•
Press the SET button will activate the off timer function.
•
Set the desired of time by pressing the SET button continuously.
•
Press the CLR button to cancel the off timer setting.
10) Automatic Air Swing (optional)
•
Press the SWING button to activate the automatic air swing function.
•
To distribute the air to a specific direction, press the SWING button and wait until the louver move to the
desired direction and press the button once again.
Page 24
1) Transmission Source
•
The source where the signal is transmitted.
2) Signal Transmission Indication
•
Blinks to confirm the last setting has been transmitted to
the unit.
3) "ON/OFF" Button
•
Press once to start the unit.
•
Press again to stop the unit.
4) Temperature Setting
•
To set the desired room temperature, press the + or –
button to increase or decrease the set temperature.
•
The temperature setting range is from 60ºF to 86ºF
(Optional setting 68ºF to 86ºF).
•
Press both buttons simultaneously to toggle + and – from
ºC to ºF setting.
5) Operation Mode
•
Press the MODE button to select the type of operating
mode.
•
For cooling only unit, the available modes are: COOL,
DRY and FAN.
•
For heat pump unit, the available modes are: AUTO,
COOL, DRY, FAN and HEAT.
6) Fan Speed Selection
•
Press the
button continuously to toggle the fan speed
in the following order:
Low
•
Stop pressing when the desired fan speed appears on
the display screen.
is pressed again or after 20 minutes.
Med
High
IM-5WMF(SEER13)-0706
Auto