Remote Controller Operation Guide - McQuay MWM 007G Manual

Remote Controller Operation Guide

G11 Remote Controller
Temperature Setting
To set the desired room
temperature, press the button to
increase or decrease the set
temperature.
The temperature setting range is
from 16 C to 30 C
Press both buttons simultaneously
to toggle the temperature setting
between C and F
Turbo Mode
Press the TURBO button to
achieve the required set
temperature in a short time.
Sleep Mode
Press the button to activate sleep
mode. This function is available
under COOL, HEAT & AUTO mode.
When it is activated in COOL
mode, the set temperature will be
increased 0.5 C after 30mins, 1 C
after 1 hour and 2 C after 2 hours.
When it is activated in HEAT mode,
the set temperature will be
decreased 1 C after 30mins, 2 C
after 1 hour and 3 C after 2 hours.
ON Timer Setting
Press the SET button will activate
the on timer function.
Set the desired on time by pressing
the SET button continuously.
Press the CLR button to cancel the
off timer setting
Clock Time Setting
Press button + or - to increase or
decrease the clock time.
Ionizer
Press the button to activate the
negative Ion function, which will
refresh the indoor air effectively.
On/Off Button
Personalised Setting
Fan Speed Selection
Operating Mode
OFF Timer Setting
Automatic Air Awing
87
Press Once to start the air
conditioner
Press again to stop the unit
Press and hold the button for 3s to
initiate personalized setting.
Set the individual setting e.g.
MODE, SET TEMP or FAN SPEED
and leave for 4s to save
2 groups of settings are allowed to
stored in the handset
Press the button until the desired
fan speed is achieved.
Press the MODE button to select
the type of operating mode.
For Cooling only unit, the available
modes are: COOL, DRY & FAN.
For Heatpump unit, the available
modes are: AUTO, COOL, DRY,
FAN & HEAT.
Press the SET button will activate
the off timer function.
Set the desired off time by pressing
the SET button continuously.
Press the CLR button to cancel the
off timer setting
Press the SWING button to
activate the automatic air swing
function.
To distribute the air to a specific
direction, press the SWING button
and wait until the louver move to
the desired direction and press the
button once again.