Table of Contents
Advertisement
Available languages
Available languages
Selector all the way to the right and hold in the Auto-Clean
position. Be careful, as hot water and steam with come out of
iron vents.
5.
Continue to hold the button down until all of the water has emptied.
If necessary, slightly tilt the iron from side-to-side and front-to-back
to aid the process.
6.
When finished, release the Steam Selector from the Auto-Clean™
position and place the iron on its heel rest. Allow the iron to
completely cool.
7.
Wipe soleplate; follow Cleaning Outside Surfaces instructions.
CLEANING OUTSIDE SURFACES
1.
Make sure the iron is unplugged and has completely cooled.
2.
Wipe the soleplate and outer surface with a soft, damp cloth. Water
and small amounts of gentle household soaps, such as dishwashing
liquid, can be used. Never use heavy-duty cleaners, vinegar or
abrasive scouring pads that may scratch or discolor the iron.
3.
After the iron has been thoroughly dried, turn the iron back on and
lightly steam over an old cloth. This will help remove any reside left
in the steam holes.
4.
When finished cleaning, turn iron off and allow time to cool
before storing.
STORING YOUR IRON
1.
Check that the iron is set to the minimum heat temperature setting and
Dry Iron steam setting ,
2.
Empty the water tank by opening the water fill door and turning the
iron upside down over a sink.
3.
Wrap cord loosely around the heel of the iron.
4.
Always store vertically on its heel to prevent water leaking from the
soleplate.
IRO N I N G T I P S A ND TRI CKS
•
The iron is designed to use ordinary tap water. A mix of 50% tap
water with 50% distilled water can be used In areas with very hard
water to reduce hard water build-up.
•
If water dripping occurs, the iron isn't hot enough to generate steam.
Allow the iron a minute to reheat and then resume ironing. Use the Dry
Iron steam setting when ironing at low temperatures.
•
Allow the iron to stand from one to two minutes when changing the
temperature setting, whether to a higher or lower setting. This allows
time for heat up or cool down. Test garment by pressing a small hidden
area to make sure temperature of iron is correct.
and completely cool.
7
™
Advertisement
Table of Contents
